How to Hotwire a Car

 

To hotwire a car:

1. Open the hood

2. Locate the coil wire. It is red. To find it follow the plug wires which lead to the coil wire. The plug wires are located at the rear of the engine on most v-8s. on six-cylinder engines the wires are on the left side near the center of the engine and on 4-cylinder engines they are located on the right side near the center of the engine.

3. run the wire from the positive (+) side of the battery to the positive side of the coil. or the red wire that goes to the coil
this gives power to the dash and the car will not start run unless it is performed first

4. locate the starter solenoid
on most mg cars it is on the starter. on fords it is located on the left-side (passenger side)

unlocking the steering wheel

5. if the car has a standard transmission make sure it is in neutral and the parking brake is on. If it is automatic, make sure it is in park

6 unlock the steering wheel using a flat blade screwdriver
take the screwdriver and place it at the top centre of the steering column. Push the screwdriver between the steering wheel and the column. Push the locking pin away from the wheel. Be very firm when pushing the pin. The pin will not break.


We assume you are seeking to enter your own car

We assume no responsibility for damage done to the car as a result of following these instructions. Follow at your own risk & expense.